Documents you can check, not adjectives you have to trust
Certificate copies, fabric test reports and audit summaries are issued with your sourcing file. Buyers may also appoint SGS, BV, Intertek or TUV to inspect before shipment.
Certifications and audit reports
Scope, issuing body and validity are listed with each document. Copies are sent on request after we confirm your company details. All certifications cover our activewear production lines.
We could not load this content. Please check your connection and try again.
Document images shown here are layout placeholders. Replace them with your own scanned certificates and reports before publishing this site.
Four inspection points, from performance fabric roll to carton
Quality is checked while the order is still recoverable, not only at the end of the line. Every stage covers activewear-specific requirements including stretch recovery, seam strength, and moisture-wicking performance.
Incoming Performance Fabric Control
Every performance fabric roll is inspected on a roller machine for shading, defects, width, stretch recovery and moisture-wicking performance. Trims, zippers and labels are checked against the approved bill of materials before release to the floor.
In-Process Patrol Check
Line QC patrols each operation hourly, verifying stitch density, seam allowance (especially four-needle coverstitch and flatlock seams), stretch recovery and measurement at the first-piece stage. Defects are corrected on the line rather than at the end.
Final Activewear Inspection
Finished activewear is measured flat against the size spec, checked for workmanship, stretch recovery and compression performance, then steam finished. Full size-set measurements are recorded and shared with the buyer.
Outgoing Carton Audit
Before loading, cartons are sampled to AQL 2.5 for packing method, polybag, hangtag, barcode and carton marking. Activewear is carefully folded to preserve stretch fabric integrity. The audit report is issued with the shipping documents.
The numbers behind our activewear quality promise
Objective standards we measure against on every activewear order, stated plainly so you can hold us to them.
Major and minor defects sampled per ISO 2859-1, general inspection level II. Buyers may appoint a third party such as SGS, BV or Intertek to witness the audit on activewear orders.
Line-level defect rate is tracked daily and reviewed each morning. Activewear styles exceeding the target are re-inspected 100% before packing, with special attention to seam strength and stretch recovery.
Every size in the activewear order is measured against spec, including stretch-fit tolerance. Out-of-tolerance garments are reworked or replaced before the carton audit.
Rework and claim policy
- Defects found in the buyer's or third-party inspection are reworked or remade at our cost.
- Inspection re-booking fees caused by our quality issues are covered by us.
- Shipment is only released after the final inspection report is approved.
- Any claim must be raised within 30 days of receipt, with photos and carton numbers.
Audit and verification support
We host customer visits and third-party audits at our Dongguan plant. Below is what we can put in your sourcing file.
- Customer-appointed third-party audits (SGS, BV, Intertek, TUV)
- Social compliance and ethical trade audit hosting
- Factory licence, organisation chart and floor plan
- Machine list, capacity sheet and production schedule
- Fabric test reports, trim certificates and MSDS where applicable
- Wage, attendance and social insurance records for audit review
Request our full compliance documents
Factory profile, machine list, capacity sheet, certificate copies and recent test reports — sent to your email, usually within one business day (GMT+8).
Request Our Full Compliance Documents